Feet, inches and fractions

Tape measure calculator

Add two lengths, subtract a gap, repeat a measurement or divide a span. Keep the exact answer beside the nearest mark your tape can actually show.

Shop math

Keep the fractions. Skip the guesswork.

First length
Second length

Use whole feet and decimal or fractional inches, such as 6.5, 1/2 or 6 1/2. Enter 0 when a field is unused. Inches above 12 carry into feet automatically.

Four everyday calculations

Worked examples with no hidden kerf or allowance
JobArithmeticResult
Add two spans8 ft 6 1/2 in + 3 ft 2 3/4 in11 ft 9 1/4 in
Subtract a clearance3 ft 0 in - 0 ft 1/8 in2 ft 11 7/8 in
Repeat a length1 ft 2 1/4 in multiplied by 33 ft 6 3/4 in
Split a span0 ft 10 in divided by 33 1/3 in exact; 3 5/16 in to the nearest 1/16

Round once, at the end

Rounding each intermediate measurement can accumulate error. This calculator uses exact fraction arithmetic internally and rounds only the final mark to the selected resolution. The ruler is an enlarged one-inch detail of that mark, not a scale to print and measure from.

Dividing a span gives equal mathematical segments, not automatically usable cut lengths. Saw kerf, end trimming, post widths and joint gaps change a real layout. Work from a consistent reference and review the whole layout before cutting.

Choose the tool for the next step

Only converting one number? Use the decimal-to-fraction converter. For multiple cuts, use the saw kerf calculator or board cut optimizer. Planning a circular top? Try the circle glue-up calculator. Record finished dimensions in the cut-list spreadsheet.

Measurement questions

Can I add feet and fractions without converting to decimals?

Yes. Enter whole feet separately and use fractional inches such as 6 1/2. SawNest keeps the arithmetic as exact fractions until rounding the final tape mark.

What happens when inches exceed twelve?

The result carries complete inches into feet. For example, 0 feet 18 inches is displayed as 1 foot 6 inches.

Does this include saw kerf?

No. This is measurement arithmetic only. Use the kerf calculator or board optimizer to account for material removed by repeated saw cuts.