Material planning • Edge banding

Buy banding for the edges you actually finish.

Count the exposed edges, add enough length to trim each strip, and see the arithmetic behind your roll estimate. This calculates banding quantity, not panel cut-size deductions.

Your panel schedule

Mix panel sizes that use the same banding material, width and finish. Run different banding specifications as separate batches.

Panel 1

Allowances for this batch

Fractions are accepted. The example allowances are not recommendations. Measure the stock and enter allowances suited to your process.

The formula, without a hidden waste factor

Net length = panel quantity × [(length × banded length edges) + (width × banded width edges)].

Trim allowance = strip count × 2 × extra length at each end. Required length = (net length + trim allowance) × (1 + waste percentage ÷ 100).

Worked example: four shelf fronts

Four 600 × 300 mm shelves with only the 600 mm front edge banded require 2,400 mm of net banding. Allowing 25 mm at each end of each of four strips adds 200 mm. A further 10% allowance gives 2,860 mm (2.86 m). A 25 m roll has enough total length; cutting feasibility still depends on usable roll sections.

Which edge is “length”?

It is the dimension you entered as panel length, not necessarily the front edge. A long front and a short front use different amounts. Two length edges plus two width edges means the full perimeter.

What this does not estimate

Do not combine different banding colors, widths or adhesive types into one roll count. This tool does not model defects, roll-piece allocation, machine setup losses, seams or material prices. Its whole-roll number is a length-only lower bound. Check the longest required strip, supplier roll length and your shop process before buying.

Keep cut size separate from finished size

Banding thickness can change the rectangular blank size when the finished dimensions must stay fixed. Use the finished-size vs cut-size guide for those deductions. Keep the reviewed blank dimensions in your cut-list spreadsheet, then import your parts to plan sheet cuts.