Measure / plan / build

Board and batten calculator

An even wall layout, with every mark accounted for.

A full batten sits at each end. Vertical battens fit between continuous rails. Use 0 for an omitted rail.

Equal clear space
19.917 in
Vertical battens7 × 41 in
Net trim length47.917 ft

Mark from the left edge

BattenLeft edge (in)Center (in)
101.75
223.41725.167
346.83348.583
470.2572
593.66795.417
6117.083118.833
7140.5142.25

Display rounded to three decimals. Mark from the original datum rather than adding rounded gaps. The last batten ends flush with the wall.

Net finished trim length, not stock purchase quantity. Openings, backing sheets, corner returns and fasteners are excluded. Allow for kerf, defects and spares.

Calculate equal board-and-batten spacing

For N spaces, use N + 1 battens, including full-width battens at each end. Clear gap = (wall width − total batten widths) ÷ N. Enter actual face widths, not nominal lumber sizes.

A 12-foot wall, worked through

A 144-inch wall with six spaces uses seven 3.5-inch battens. The clear gap is (144 − 7 × 3.5) ÷ 6 = 19.916667 inches. Centers repeat at 23.416667 inches. For a 48-inch panel with 3.5-inch top and bottom rails, each batten is 41 inches long.

Measure from one datum

Mark every batten from the original left edge, not by repeatedly adding rounded gaps. Dry-fit around outlets and trim. This calculator does not automatically redistribute battens around windows or doors.

Turn the cut list into a purchase plan

The list shows finished lengths, not how many boards to buy. Use the board optimizer to fit lengths into stock with kerf. Estimate backing coverage with the square-footage calculator. This is for decorative interior trim, not structural design or exterior siding installation.