Cabinet fronts / layout and cut sizes

Drawer front spacing calculator

Fit equal fronts to one cabinet opening, with every reveal and gap accounted for. Take a clear marking schedule to the bench instead of adding rounded dimensions as you go.

Fit the opening

One bank. Even gaps.

Fronts sit inside the opening. Reveals are the clear space around the outer edges.

Enter decimals, such as 0.125 for 1/8 inch. Changing units converts the same physical measurements. One front ignores the between-front gap.

Cut sizes and marking schedule

23.75 × 9.83333 in

Finished width × height of each front. Make 3 equal fronts.

Opening: 24 × 30 in. Reveals: top 0.125, bottom 0.125, each side 0.125 in. Between-front gap: 0.125 in.

FRONT ELEVATION / INSET12323.75 inDashed: opening. Numbers match the schedule.Not a drilling template. Do not measure this drawing.
All marks measured down from the opening’s top edge (in)
FrontTopCentreBottom
10.1255.041679.95833
210.083331519.91667
320.0416724.9583329.875

Marks use unrounded dimensions internally; displayed values use up to five decimal places. Measure from the same datum rather than stacking rounded front heights.

Front sizes only: no drawer-box, runner, handle-hole or hinge dimensions. Check opening squareness, finish thickness, edging and hardware clearances before cutting.

A three-front bank, worked through

Start with a 24-inch-wide, 30-inch-high opening. Use three inset fronts with a 1/8-inch reveal at the top, bottom and each side, plus 1/8-inch gaps between fronts.

Each front is 23.75 inches wide. The available height is 30 − 0.125 − 0.125 − (2 × 0.125) = 29.5 inches. Divide by three for a front height of 9.833333… inches. The final front ends at 29.875 inches, leaving the specified bottom reveal.

Inset and overlay use different boundaries

Inset fronts sit inside the opening, so subtract the perimeter reveals. Overlay fronts extend beyond it, so add the top, bottom and side overlays. Gaps between fronts are subtracted in both cases. This tool assumes a single vertical bank of equal-height rectangular fronts, with equal left and right allowances.

Cut size is not drawer-box size

Measure the opening in several places and check that it is square. Choose gaps that suit the material, finish and hardware. The result is the finished front size, not a rough blank with edge banding or machining allowance added. It does not set runner position or certify a joint or mounting method.

Next, size the boxes with the drawer-box calculator, plan matching Shaker doors, or enter the finished rectangles in the sheet cut optimizer. Record a complete job in the Excel cut-list template.